Drywall is simple to install and very easy to repair. Drywall damage may range from small holes to large cracks, but in most cases drywall repairs are easy to fix. It is a task that should only be performed by experts since inappropriate drywall repair can leave a lumpy mess that declares “rough” to a stranger.
According to the Bedford Hills paint and hardware contractors, the best way to do a repair drywall is to use two or three coats of compound and the most important thing when repairing drywall is to build the joint out wider than you would normally. Mentioned below are the stages how to repair drywall.
Surface Crack Repair:
Drywall is not like plaster, it has a flawless paper casing that rarely cracks or splits. However, in some rare cases when crack appears, it is usually seen on a seam where two drywall sheets meet. This type of surface crack can be easily fixed. If you find the crack on the vertical or horizontal seam of the drywall, you can take time to properly extend the crack with the corner of a paint scraper. You can even use a utility knife or chisel to determine whether the crack extends completely through the paper that is covering the seam. It is also important to find out whether the tape has pulled loose from the wall surface.
You need to fill the cracks with a new compound by holding the knife at a seventy-degree angle and by swiping the knife across the crack. Allow the joint compound to dry properly then lightly sand the area.
Deep Crack Repair:
If you find a deep crack that extends through the seam’s paper tape, you should use a blade to cut the tape about six to twelve inches from either ends of the cracks. Scrape away any loose compound and then fill the crack with high quality drywall compound. You also need to apply a thin coat of compound to the wall surface where the old tape was removed.
Nail Pop Repair:
Nail pop is a common drywall problem that is mainly seen in newer homes. This is typically caused by warped dry wood. You can use a utility knife to scrape away the drywall until the screw is exposed. It is important to drive the nail back into the stud by using a screwdriver or hammer. When using screws, always remember to recess the heads slightly, this would create a dimple in the drywall surface.
